Check the height of the infeed and outfeed

WHAT YOU NEED 

Standard Personal Protective Equipment

CAUTIONWhen using the manual mode, make sure that everything and everyone is clear of moving parts to prevent damage or injuries.

  1. Rehome the saw to make sure the printer is in the highest possible position.
  2. Using the Manual Mode window, load a straight high quality board (6 m long and 90 mm wide).
  3. Move the board towards the outfeed until the end of the board is across the OFK conveyor by at least 100 mm.
  4. Check that the gap between the bottom of the timber and the top of the OFK conveyor does not exceed 1 mm.
  5. Check that the AIT conveyor rollers are not putting excessive upward pressure on the board.
  6. Check that the free running rollers on the infeed chute are not directly contacting the bottom of the board. If they do contact, lower the free rolling infeed chute or increase the angle with the mounting/jacking bolts.
  7. Move the board towards the outfeed and stop about 100 mm prior to passing the last powered roller on the AIT.
  8. Check that the gap between the bottom of the timber and the top of the AIT conveyor roller does not exceed 1 mm.
  9. Check that the OFK conveyor is not putting excessive upward pressure on the board.